Reply to "Red Dot Sights for Handguns"

I have a 508T (V1) mounted on a GEN 5 Glock 19 MOS using a C&H Precision Weapons adapter plate (V3).  I only have 600 rounds fired, but so far everything has remained tight and zero maintained.  I went from a RMR Type 2 to the 508T for the Holosun circle dot reticle.  I had significant visual distortion with the RMR Type 1 and Type 2 dot (and every other dot for that matter).  The circle dot reticle on the Holosun is a clear image for some reason.  I found the auto brightness mode on the Holosun to not really work for me.  Usually too dim or too bright depending on light conditions.  I have it set to manual brightness.  I have not noticed any lag time on the auto off feature.  A couple of other points.  The first 508T I received was dead on arrival.  It was replaced with no hassle.   There is a 508T V2 that was announced at Shot Show.  Biggest difference is side battery load vs bottom.  I preordered the 509T a month ago and within the last week it went from shipping in days to shipping in months.  I’m guessing the same will hold true for the 508T V2.  I suspect that due to virus related supply chain issues, we won’t see these products for a while.  Also, we may see existing stock dwindle as supply lags.  I picked up an additional 508T V1 in the meantime.  BTW, this is a non-duty use setup.  Hope this helps a bit.

Also, C&H has a V4 adapter plate that is supposed to drop in April. 

Last edited by Community Member
Copyright Lightfighter Tactical Forum 2002-2020
×
×
×
×
×